<div>Problem:<br><br>The VPN client fails to connect to my gateway. When I click on connect,<br>the client application seems to connect briefly, but then immediately reports "session terminated by gateway" (full console log below)<br>
<br>To Reproduce:<br><br>Connect to Cisco VPN.<br><br>VPN Client Version = 2.1.5 RC2<br>Windows OS Version = Windows 7 RTM<br>Gateway Make/Model = Cisco VPN Concentrator (not ASA)<br>Gateway OS Version = ?<br><br>debug.zip [attachment]</div>

<div>I could not get the decrypted ike dump to work on this OS and/or version of Shrew.</div>
<div> </div>
<div>What I see on the console is the following:</div>
<div> </div>
<div>config loaded for site 'Houston'</div>
<div>configuring client settings ...</div>
<div>attached to key daemon ...</div>
<div>peer configured</div>
<div>iskamp proposal configured</div>
<div>esp proposal configured</div>
<div>client configured</div>
<div>local id configured</div>
<div>pre-shared key configured</div>
<div>bringing up tunnel ...</div>
<div>network device configured</div>
<div>tunnel enabled</div>
<div>session terminated by gateway</div>
<div>tunnel disabled</div>
<div>detached from key daemon ...</div>
<div> </div>
<div>I have another PCF file over here to a different VPN Concentrator at my organization that works.  I have inspected the 2 PCFs and the only real difference I can see is that in sample1.pcf, the group name has an underscore character.  sample2.pcf does not, and seems to connect fine. So, this could either 1) be a problem with the import process or 2) my two VPN concentrators are configured differently.</div>

<div> </div>
<div>Any thoughts on how to make this work?<br></div>