<div dir="ltr"><div><strong>Problem</strong>:</div><div>After initial installation and configuration of the VPN tunnel, Shrew Soft successfully connects and passes traffic to/from network devices.  The tunnel connects rapidly.</div>
<div> </div><div>After closing/disconnecting the tunnel, subsequent connections succeed, but slowly.  After the tunnel is enabled, traffic will no longer pass.  Quitting the Shrew Soft client, rebooting the PC, have no effect.</div>
<div> </div><div> </div><div><strong>Workaround:</strong></div><div>The only workaround discovered so far is to perform the following steps in sequence:</div><div>1) Open Network and Sharing Center in the Control panel.</div>
<div>2) Right click on the LAN connection, select 'properties', deselect the "Shrew Soft Lightweight Filter", click 'ok' to save.</div><div>3) Right click on the LAN Connection, select 'disable'.</div>
<div>4) Right click on the LAN Connection, select 'enable'</div><div>5) Right click on the LAN connection, select 'properties', select the "Shrew Soft Lightweight Filter", click 'ok' to save.</div>
<div> </div><div> </div><div><strong>Environment</strong>:</div><div>Shrew Soft VPN Client (Std) 2.2.2</div><div>Windows 7 SP1</div><div>Dell OptiPlex 3010 </div><div>Realtek PCIe GBE (Driver 5.810.1218.2012)</div><div>Cisco SA500</div>
<div> </div><div> </div><div>Any suggestions would be appreciated.</div><div> </div><div> </div></div>