[vpn-help] Gui strangely changing config entries
Clemens Perz
cperz at gmx.net
Wed Mar 31 12:22:47 CDT 2010
Hi,
I saw that too. I installed 2.1.6-beta-4 on Ubuntu 9.10. When you open
the settings, uncheck the banner and save - the banner will not be
shown. Reopen the page in the gui, the option is checked again, but
still will not be shown on connect. But if you change anything in the
config and save it, the connect banner is back - until you switch it off
and save again.
Cheers,
Clemens
Michael wrote:
> Hello list,
>
> When using the Qt GUI to configure 'n:client-banner-enable:0' and
> turn it off, I continue by pressing 'Save'. If I go back and look
> at the configuration afterwards, then banner setting is enabled
> again and set to 'n:client-banner-enable:1'. What is going on?
>
> A similar problem (or misunderstanding) ocurrs when I set the
> 's:ident-client-type:asn1dn' to ASN.1. After saving and coming
> back the entry is always set to 's:ident-client-type:fqdn'.
>
> I'm using the Shrew ike daemon (packaged with the Qt client)
> version 2.1.4 on Ubuntu Linux 9.10.
>
> Does anyone know the reason for this strange behaviour?
>
> Thanks,
> Michael
> _______________________________________________
> vpn-help mailing list
> vpn-help at lists.shrew.net
> http://lists.shrew.net/mailman/listinfo/vpn-help
>
More information about the vpn-help
mailing list