[vpn-help] Netgear Prosafe DGFV338 Gateway Mode Config help

[Michal Wegrzyn]

Hello,

Shrew and Netgear with ModeConfig works only if in ModeConfig you select XAUTH, without that Shrev won't establish a connection.

PS: In ModeConfig record you put any pool that is different from your LAN, DMZ, WAN - client will get address from this pool when it connects.

Regards,
 Michal Wegrzyn
  ----- Original Message ----- 
  From: Patrick MacEwen 
  To: vpn-help at lists.shrew.net 
  Sent: Wednesday, January 13, 2010 1:36 PM
  Subject: [vpn-help] Netgear Prosafe DGFV338 Gateway Mode Config help


  Hello

  I require to set up a tunnel between a windows 7 pro (64 bit) client using release 2.1.5 and a netgear prosafe DGFV338.

   

  I'm comfortable following the netgear commercial gateway howto in the support section.

   

  However, In setting up the Mode Config Record -  I'm not sure which IP addresses I should put in there ( both in the client pool and Traffic Tunnel Security settings)

   

  My gateway local IP address is 192.168.10.1/255.255.255.0

   

  Could anyone advise as to what my Pool IP address, wins and dns server settings should be set to and also should I use 192.168.10.1 as my "Local IP address etc?

   

  Many thanks

  Patrick MacEwen

   



------------------------------------------------------------------------------


  _______________________________________________
  vpn-help mailing list
  vpn-help at lists.shrew.net
  http://lists.shrew.net/mailman/listinfo/vpn-help
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.shrew.net/pipermail/vpn-help/attachments/20100113/02b04345/attachment-0002.html>