[vpn-help] Issues connecting to company VPN using a "Pocket WiFi - LTE" access point

[Guido 嵬 到]

Hi Alexis,

Thanks for your reply! As you suggested this was indeed a problem with
transforms... I managed to solve my issue by setting the 'esp-3des'
transform algorithm explicitly (instead of 'auto') in the Phase2 tab.
I think that I still have some fragmentation problem, but at least
this is a step forward ;-) Thanks again for your help.

Regards,

Guido



2014-05-05 9:42 GMT+02:00 Alexis La Goutte <alexis.lagoutte at gmail.com>:
> Hi Guido,
>
> Do you have try to remove some transform (in Phase 2) because there is
> a lot of transform (> 40) and there is may be a problem of IP
> fragmentation !
>
> Regards,
>
> On Sun, May 4, 2014 at 5:13 AM, Guido 嵬 到 <guido.out at aversano.org> wrote:
>> Hi,
>>
>> I am experiencing problems connecting to my company VPN, using the
>> 2.2.2 client on Windows 8.1 / 32bit (imported PCF configuration).
>> The connection is established, but no traffic passes through, and I
>> get disconnected by the server after a while. If I look at security
>> associations in the VPN Trace utility, I can see 2 associations remain
>> in LARVAL state, before forced disconnection, and no bytes are
>> exchanged. Please see my logs attached for more info.
>>
>> The problem appears only when I am connected to the internet by a
>> Pocket WiFi - LTE cellular access point that I rented in Japan,
>> otherwise the client works fine.
>> I thought to a NAT/firewall issue with the access point, but note that
>> I manage to connect using the same Pocket WiFi access point, but using
>> iOS Cisco VPN software embedded in my iPad.
>>
>> I would really appreciate any help from you all on this issue!
>>
>> Regards,
>> Guido
>>
>> _______________________________________________
>> vpn-help mailing list
>> vpn-help at lists.shrew.net
>> https://lists.shrew.net/mailman/listinfo/vpn-help
>>